Installing The Battery Pack - Datalogic PowerScan PM9100 Series Quick Reference Manual

Installing the Battery Pack

Installing the Battery Pack
To install, charge and/or do any other action on the bat-
tery, follow the instructions in this manual.
NOTE
WARNING
WARNING
4
To charge the Battery Pack, See "Charging
the Batteries" on page 7.
Datalogic recommends annual replacement
of rechargeable battery packs to ensure
maximum performance.
Do not discharge the battery using any
device except for the scanner. When the bat-
tery is used in devices other than the desig-
nated product, it may damage the battery or
reduce its life expectancy. If the device
causes an abnormal current to flow, it may
cause the battery to become hot, explode or
ignite and cause serious injury.
Lithium-ion battery packs may get hot,
explode or ignite and cause serious injury if
exposed to abusive conditions. Be sure to
follow the safety warnings that follow:
• Do not place the battery pack in fire or heat.
• Do not connect the positive terminal and
negative terminal of the battery pack to each
other with any metal object (such as wire).
• Do not carry or store the battery pack
together with metal objects.
• Do not pierce the battery pack with nails,
strike it with a hammer, step on it or other-
wise subject it to strong impacts or shocks.
• Do not solder directly onto the battery pack.
• Do not expose the battery pack to liquids, or
allow the battery to get wet.
• Do not apply voltages to the battery pack
contacts.
In the event the battery pack leaks and the
fluid gets into your eye, do not rub the eye.
Rinse well with water and immediately seek
medical care. If left untreated, the battery
fluid could cause damage to the eye.
PowerScan™ PM9100