Table of Contents
Advertisement
Installing the Battery Pack
To install, charge and/or do any other action on the battery, follow the
instructions in this manual.
NOTE
WARNING
Quick Reference Guide
To charge the Battery Pack, See "Charging the Batteries" on
page 7.
Datalogic recommends annual replacement of rechargeable
battery packs to ensure maximum performance.
Do not discharge the battery using any device except for the
scanner. When the battery is used in devices other than the
designated product, it may damage the battery or reduce its
life expectancy. If the device causes an abnormal current to
flow, it may cause the battery to become hot, explode or ignite
and cause serious injury.
Lithium-ion battery packs may get hot, explode or ignite and
cause serious injury if exposed to abusive conditions. Be sure to
follow the safety warnings listed below:
• Do not place the battery pack in fire or heat.
• Do not connect the positive terminal and negative terminal of
the battery pack to each other with any metal object (such as
wire).
• Do not carry or store the battery pack together with metal
objects.
• Do not pierce the battery pack with nails, strike it with a ham-
mer, step on it or otherwise subject it to strong impacts or
shocks.
• Do not solder directly onto the battery pack.
• Do not expose the battery pack to liquids, or allow the battery
to get wet.
• Do not apply voltages to the battery pack contacts.
In the event the battery pack leaks and the fluid gets into your
eye, do not rub the eye. Rinse well with water and immediately
seek medical care. If left untreated, the battery fluid could
cause damage to the eye.
Installing the Battery Pack
5
Advertisement
Table of Contents
