Switching The Appliance Off; Gas Tap Maintenance - Whirlpool WS67E4KHX/MEA Manual

Table of Contents

Advertisement

Available languages

Available languages

EN
CLEANING AND MAINTENANCE
TURN OFF THE MAIN SWITCH AND ENSURE
THE COOKER IS COLD BEFORE CLEANING.
Do not use steam cleaning
equipment.
Use protective gloves during all
operations.
Disconnect the appliance from the power
Respecting and conserving the environment
• Whenever possible, avoid pre-heating the oven
and always try to fill it. Open the oven door as little
as possible because heat is lost every time it is
opened. To save a substantial amount of energy,
simply switch off the oven 5 to 10 minutes before the
end of your planned cooking time and use the heat
the oven continues to generate.
• Keep gaskets clean and tidy to prevent any door
energy losses
• If you have a timed tariff electricity contract, the "delay
cooking" option will make it easier to save money by
moving operation to cheaper time periods.
• The base of your pot or pan should cover the hot plate.
If it is smaller, precious energy will be wasted and
pots that boil over leave encrusted remains that can
be difficult to remove.
• Cook your food in closed pots or pans with well-fitting
lids and use as little water as possible. Cooking with
the lid off will greatly increase energy consumption
• Use purely flat pots and pans
• If you are cooking something that takes a long time,
it's worth using a pressure cooker, which is twice as
fast and saves a third of the energy.

Switching the appliance off

Disconnect your appliance from the electricity supply
before carrying out any work on it.
*
The cover
when the burners are alight or when they are still hot.

Gas tap maintenance

Over time, the taps may become jammed or difficult to
turn. If this occurs, the tap must be replaced.
EXTERIOR SURFACES
• Clean the surfaces with a damp microfibre cloth.
If they are very dirty, add a few drops of pH-neutral
detergent. Dry them with a dry cloth.
• Do not use corrosive or abrasive detergents. If any of
these products inadvertently comes into contact with
the surfaces of the appliance, clean immediately with
a damp microfibre cloth.
*Only available in certain models
BEFORE SWITCHING ON AGAIN, ENSURE THAT
ALL CONTROLS ARE IN THE OFF POSITION.
Carry out the required
operations when the oven is cold.
Disconnect the appliance from
the power supply.
supply.
If the cooker is fitted with
a glass cover, this cover
should be cleaned using
lukewarm water. Do not use
abrasive products.
It is possible to remove
the cover in order to make
cleaning the area behind
the hob easier. Open
the cover fully and pull it
upwards (see figure).
! Do not close the cover
Do not use wire wool, abrasive
scourers or abrasive/corrosive
cleaning agents, as these could
damage the surfaces of the
appliance.
MOVING THE TOP HEATING ELEMENT
1.
R emove the side accessory holder grills.
2.
P ull the heating element out a little ( Fig. 1) and
lower it ( Fig. 2 ).
3.
To reposition the heating element, lift it up,
pulling it slightly towards you, making sure it
comes to rest on the lateral support.
Fig. 1
INTERIOR SURFACES
• After every use, leave the oven to cool and then
clean it, preferably while it is still warm, to remove any
deposits or stains caused by food residues To dry any
condensation that has formed as a result of cooking
foods with a high water content, let the oven to cool
completely and then wipe it with a cloth or sponge.
• Clean the glass in the door with a suitable liquid
detergent.
ACCESSORIES
Soak the accessories in a washing-up liquid solution
after use, handling them with oven gloves if they
are still hot. Food residues can be removed using a
washing-up brush or a sponge.
REPLACING THE LIGHT
1. Disconnect the oven
2. Unscrew the cover from the light,
3.
Note: Use 40 W/230 V type
Note: Use 40 W/230 V type
The bulb used in the product is specifically designed for
The bulb used in the product is specifically designed for
The bulb used in the product is specifically designed for
The bulb used in the product is specifically designed for
domestic appliances and is not suitable for general room
domestic appliances and is not suitable for general room
domestic appliances and is not suitable for general room
domestic appliances and is not suitable for general room
lighting within the home (EC Regulation 244/2009).
lighting within the home (EC Regulation 244/2009).
lighting within the home (EC Regulation 244/2009).
lighting within the home (EC Regulation 244/2009).
Light bulbs are available from our After-sales Service.
Light bulbs are available from our After-sales Service.
Light bulbs are available from our After-sales Service.
Light bulbs are available from our After-sales Service.
- Do not handle bulbs with your bare hands as your
- Do not handle bulbs with your bare hands as your
- Do not handle bulbs with your bare hands as your
- Do not handle bulbs with your bare hands as your
fingerprints could damage them. Do not use the oven until
fingerprints could damage them. Do not use the oven until
fingerprints could damage them. Do not use the oven until
fingerprints could damage them. Do not use the oven until
the light cover has been refitted.
the light cover has been refitted.
the light cover has been refitted.
the light cover has been refitted.
24
Fig. 2
from the power supply
replace the bulb
and screw the cover back on the light.
Reconnect the oven to the power supply.
G9

Advertisement

Table of Contents
loading

Table of Contents