Table of Contents
Advertisement
Changing the Hydraulic
Fluid
Service Interval: Every 400 hours/Yearly (whichever
comes first)
1.
Park the machine on a level surface.
2.
Raise the loader arms and install the cylinder
lock.
3.
Shut off the engine, remove the key, and allow
the engine to cool.
4.
Open the hood.
5.
Remove the hydraulic-tank cap and dipstick
(Figure
62).
Note:
The filler cap is behind the front screen.
If you want to improve your access to it, remove
the screen.
Figure 62
1. Filler neck
6.
Place a large drain pain capable of holding 57 L
(15 US gallons) under the drain plug on the front
of the machine
(Figure
g004357
2. Dip stick
63).
1. Drain plug
7.
Remove the drain plug and allow the oil to drain
into the pan
(Figure
8.
When finished, install and tighten the drain plug.
Note:
Dispose of the used oil at a certified
recycling center.
9.
Fill the hydraulic tank with hydraulic fluid as
specified in
Hydraulic Fluid Specifications (page
43).
10.
Start the engine and let it run for a few minutes.
11.
Shut off the engine.
12.
Check the hydraulic-fluid level and add fluid to
fill the tank if necessary; refer to
Hydraulic-Fluid Level (page
13.
Close the hood.
45
Figure 63
63).
Checking the
43).
g004213
Advertisement
Table of Contents
