Table of Contents
Advertisement
Maintenance Service
Interval
Every 100 hours
Every 200 hours
Every 250 hours
Every 400 hours
Every 500 hours
Every 1,500 hours or
2 years, whichever
comes first
Yearly
Yearly or before storage
Every 2 years
Important:
Refer to your engine owner's manual for additional maintenance procedures.
Pre-Maintenance
Procedures
Using the Cylinder Lock
WARNING
The loader arms may lower when in the raised
position, crushing anyone under them.
Install the cylinder lock(s) before performing
maintenance that requires raised loader arms.
Installing the Cylinder Lock
1.
Remove the attachment.
2.
Raise the loader arms to the fully raised position.
3.
Shut off the engine and remove the key.
4.
Remove the lynch pin securing the cylinder lock
to the loader arm
Maintenance Procedure
• Change the engine oil. (Service more frequently if conditions are extremely dusty
or sandy.)
• Check and adjust the track tension.
• Check the cooling system hoses.
• Check the hydraulic lines for leaks, loose fittings, kinked lines, loose mounting
supports, wear, weather, and chemical deterioration.
• Check for dirt buildup in the chassis.
• Check the alternator/fan belt tension (refer to the engine owner's manual for
instructions).
• Change the oil filter. (Service more frequently if conditions are extremely dusty
or sandy.)
• Replace the hydraulic filter.
• Check and grease the road wheels.
• Check the fuel lines and connections for deterioration, damage, or loose connections.
• Replace the fuel filter canister and in-line filter.
• Change the hydraulic fluid.
• Replace the alternator/fan belt (refer to the engine owner's manual for instructions).
• Replace all moving hydraulic hoses.
• Change the engine coolant.
• Check the condition of the hydraulic pump belt.
• Check and adjust the track tension.
• Touch up chipped paint.
• Drain and clean the fuel tank(s)—Authorized Service Dealer only.
(Figure
23).
1. Cylinder lock
2. Lift cylinder
5.
Lower the cylinder lock over the cylinder rod and
secure it with the lynch pin
6.
Slowly lower the loader arms until the cylinder
lock contacts the cylinder body and rod end.
23
Figure 23
3. Lynch pin
(Figure
23).
g004182
Advertisement
Table of Contents
