Servicing The Engine Oil - Toro 22323HD Operator's Manual

Compact tool carrier

Hide thumbs

Table Of Contents

Table of Contents

1. Dust cap

2. Latch

3. Air-cleaner cover

Squeeze the dust cap sides to open it and knock

the dust out.

Clean the inside of the air-cleaner cover with

compressed air that is under 205 kPa (30 psi).

Important:

Do not use compressed air on

the air-cleaner body.

Check the service indicator.

•

If the service indicator is clear, install the

air-cleaner cover with the dust cap oriented

downward and secure the latches

30).

•

If the service indicator is red, replace the

air filter as described in

(page

27).

Replacing the Filter

Important:

To prevent engine damage, always

operate the engine with the air filter and cover

installed.

Gently slide the filter out of the air-cleaner body

(Figure

30).

Note:

Avoid knocking the filter into the side of

the body.

Important:

Do not attempt to clean the filter.

Inspect the new filter for tears, an oily film, or

damage to the rubber seal. Look into the filter

while shining a bright light on the outside of the

filter; holes in the filter appear as bright spots.

If the filter is damaged, do not use it.

Carefully install the filter

Note:

Ensure that the filter is fully seated

by pushing on the outer rim of the filter while

installing it.

Figure 30

4. Primary filter

5. Air-filter body

6. Service indicator

(Figure

Replacing the Filter

(Figure

30).

Important:

area of the filter.

Install the air-cleaner cover with the dust cap

oriented downward and secure the latches

(Figure

30).

Close the hood.