Table of Contents
Advertisement
1. Fuel-filter canister/water
separator
2. Drain valve
4.
Loosen the drain valve on the bottom of the filter
canister and allow the water to drain.
5.
When finished, tighten the drain valve.
Replacing the Fuel Filter
Canister and In-Line Filter
Service Interval: Every 400 hours
1.
Park the machine on a level surface, engage the
parking brake, and lower the loader arms.
2.
Shut off the engine and remove the key.
3.
Open the rear-access cover; refer to
the Rear-Access Cover (page
4.
Locate the fuel filters on the right side of the
engine
(Figure
35) and place a clean container
under it.
5.
Clean the area where the filter canister mounts
(Figure
35).
6.
Remove the filter canister and clean the
mounting surface
7.
Lubricate the gasket on the new filter canister
with clean oil.
8.
Fill the canister with fuel.
9.
Install the filter canister by hand until the gasket
contacts the mounting surface, then rotate it an
additional 1/2 turn
Figure 35
3. Hose clamps
4. In-line filter
Opening
25).
(Figure
35).
(Figure
35).
10.
Locate the in-line filter to the left of the fuel filter
canister
(Figure
flow arrow on the side of the in-line filter.
11.
Open the clamps on each end of the in-line filter
and slide the hoses off it
the filter.
12.
Slide the hoses over the end of a new filter
(Figure
35), ensuring that the arrow on the filter
is pointing toward the engine or electric fuel
pump.
13.
Secure the hoses to the filter with the hose
clamps.
14.
Close the rear-access cover and secure with the
fastener(s).
Bleeding the Fuel System
You must bleed the fuel system before starting the
engine if any of the following situations have occurred:
g009626
•
Initial startup of a new machine
•
The engine has ceased running due to a lack of
fuel.
•
Maintenance has been performed on fuel system
components (e.g., filter replaced).
1.
Park the machine on a level surface, lower the
loader arms, and shut off the engine.
2.
Ensure that the fuel tank is at least half full.
3.
Open the hood.
4.
Open the air-bleed screw on the fuel-injection
pump
(Figure
1. Air-bleed screw
30
35) and note the direction of
(Figure
35). Discard
36).
Figure 36
g003880
Advertisement
Table of Contents
