Troubleshooting And Error Table - Hisense WFQP8014EVM User's Operation Manual

TROUBLESHOOTING AND ERROR TABLE

Problem/ Indication on the display unit and
error problem description
E0 Incorrect settings
E1 Temperature sensor error.
E2 Door lock error.
E3 Water filling error.
E4 Motor error
E5 Motor error
E6 Water heating error
E7 Water draining error
50
What to do?
Restart the programme. If the error reoccurs,
call a service technician.
Inlet water too cold. Repeat the washing
programme.
If the washing machine reports this error again,
call a service technician.
Make sure the washing machine door is closed.
Unplug the power cord from the outlet; then,
plug the power cord back into the outlet and
switch on the washing machine.
If the error reoccurs, call a service technician.
Check the following:
• is the water inlet valve open,
• is the filter on the water supply hose clean,
• is the water supply hose deformed (clipped,
clogged etc.),
• is the pressure in the water mains between
0.05 and 0.8 MPa (0,5–8 bar).
Then, press the (3) START/PAUSE button to
resume the programme. If the error reoccurs,
call a service technician.
Restart the programme. If the error reoccurs,
call a service technician.
Restart the programme. If the error reoccurs,
call a service technician.
Restart the programme. If the error reoccurs,
call a service technician.
Check the following:
• is the pump filter clean,
• is the discharge hose clogged,
• is the drain clogged,
• if the discharge hose placed is placed below
the maximum and above the minimum
height (see chapter »INSTALLATION AND
CONNECTION/ Connecting and securing the
water discharge hose«);
then, press the (3) START/PAUSE button
again. If the error reoccurs, call a service
technician.