Chapter6 Heater Mode; Heater Template; Select Heat Mode; Edit Heat Mode - FIBER FOX MINI3S User Manual

Chapter 6 Heater Mode
The splicer provides max 32 heat modes including 5 heat modes preset by factory
and the rest that can be defined by users. Select a heating mode that best matches
with the protection sleeve used.
For each type of protection sleeve, MINI3S has its optimum heating mode. These
modes can be found in the database area for reference. Copy the appropriate mode
and paste it to the user–programmable area. Users can edit those parameters.

6.1 Heater Template

Parameter
60mm For standard protection sleeve of 60mm
40mm For standard protection sleeve of 40mm.
33mm For standard protection sleeve of 33mm

6.2 Select Heat Mode

To select another heating mode
other than the active one, you must
enter Select heat mode menu.
① Enter main menu
② Select Heater Mode
26
Description
③ Touch on Select Heat mode
④ Back to original interface

6.3 Edit Heat Mode

Tube-heating conditions stored
in heating mode can be edited or
changed.
① Enter edit heat mode menu via
touching on heater mode menu.

6.4 Deleting Heat Mode

① Select Heater mode menu.
② Select Delete Heat Mode.
③ Select the heat mode to be
deleted
Note: The gray mode (40mm,
60mm) is the system preset
initial heat modes which cannot
be deleted.
27