Advertisement
Section 1 - Single Amplifier Installation in Street Glide / Ultra - Cont.
8. The balance of the main wire harness will pass under the inner fairing where the main
wire harness passes through on the brake side of the bike. Loosen the tank console and
run wires up and over the gas tank, but under the tank console. There is a provision on
the front of the tank console for wires to pass. Secure the amplifier's harness to the bike's
factory harness using zip ties. When correctly installed, the power and ground wires are
the correct length to connect to the battery.
Figure 1.3 - Stock Harness and
Amplifier's Harnesses Passing
From Fairing To Just In Front
Of Tank (Arrow A). Cable Tying
the 2 Amp Harnesses to the
Main Bike Harness Just In
Front Of The Tank (Arrow B)
Allows The Amp Harnesses
To Go Up Towards The Tank's
Chrome Console Easier And
Makes For a Cleaner Install.
NOTE: Although not necessary, you can run the harness along the backbone of the bike's
frame if you choose to remove and re-install the bike's fuel tank.
• Attach the red wire to the positive (+) battery terminal and the black wire to the
negative (-) battery terminal. The factory battery wires are also re-installed at this
point. Turn the ignition of the bike to the "on" position and play the stereo at low
volume to verify the amplifier is working properly.
Now is a good time to "clean up" and secure any wiring inside or your fairing using
supplied zip ties. For the best possible FM reception, DO NOT attach any of the
amplifier's wiring to any factory antenna wires! If you are installing a second XM160-2
amplifier, please go to Section 3 of this manual.
IMPORTANT: With all wires secured, turn the front
wheel to each extreme side, making sure that any
wires cannot bind or impede the steering of the
motorcycle. Failure to do so can cause an accident
resulting in serious injury or death!
If this is the only amplifier being installed, please go to "Final System Adjustments" on
page 10 of this manual.
A
B
5
Advertisement
