Advertisement
Section 1 - Installation Instructions to KENWOOD
CA-CUT14 for 2014-Current Bikes
Installation procedure
The CA-CUT14 (sold separately) enables you to install the XM69R speakers into select
hard saddlebag lids without a pre-existing speaker option. Please reference the CA-CUT14
instruction manual for detailed installation instructions.
Section 2 - Installation Instructions to KENWOOD
CA-LID98 Lids for 1998-2013 Bikes
Note: This is written as if you already had the lids on and are simply changing the speakers.
With the speakers that were in the lids removed, locate the bag in the box for 98-13 "AA"
lids. These are soft black silicone gaskets that go between the speakers and the lids and
MUST be installed correctly to keep water out. One side of the gaskets has a groove on the
inside, and the other side has a groove on the outside. On the underside of the lid, you will
see a "lip" that goes around the speaker opening. The side of the gasket with the groove
on the inside will "mate" to the lip around the speaker opening on the lid.
IMPORTANT: The gasket will come close to one of the 2 holes where screws go through to
secure the grille as shown by the arrow in Fig 1.1 (below).
The gasket MUST be oriented so the "notch" in the silicone gasket goes around this screw
boss.
Figure 1.1
3
Advertisement
