Advertisement
Section 2 - Installation Instructions to KENWOOD
CA-LID98 Lids for 1998-2013 Bikes
On the speaker itself, you will see a "lip" that goes around the perimeter of the speaker's
steel frame. The side of the gasket with the groove on the outside will "mate" to the lip
around the speaker. IMPORTANT: The "end" of the speaker with the small circuit board
and speaker connectors must be placed so they are closest to the REAR of the lid. Take a
moment to check that the gasket is sitting correctly on the lid and the speaker is sitting
correctly on the gasket before securing the speaker to the lid using the silver Phillips pan
head screws.
Section 3 - Installation Instructions for another brand
of 6" x 9" lids
Most aftermarket saddlebag speaker lids fit a common-sized 6" x 9" speaker like the ones
in this kit. Locate the bag for the 14+ "RM" lids. These are soft black silicone gaskets that
go between the speakers and the lids. One side of the gaskets has a groove on the inside,
and the other side has a groove on the outside. The side of the gasket with the groove on
the outside will "mate" to the lip around the speaker. With the gasket in place, secure the
speaker to the lids you are using.
4
Advertisement
