Advertisement
Section 1 - Getting Started - Cont.
3. Locate the wire harness and take the 48" section with the silicone grommet in line and
install it into the saddle bag, making sure the 2 speaker "spades" are on the inside of the
bag and the single 2-pin connector is on the outside of the bag. The black squares (also in
Fig 1.1) are an approximation of where the supplied zip tie peel and stick "anchors" will be
placed.
NOTE: Note: Before applying the anchors, you need to clean the plastic WELL using 99%
isopropyl alcohol, or a similar cleaner. DO NOT use Acetone (it will eat plastic). Do not
apply pads until the cleaner has completely evaporated.
Section 2 - Disassembling The Factory Lid
NOTE: The kit comes with 2 types of screws:
6 (each) Phillips head screws with a pointy end
•
16 (each) Phillips "Thread Forming" screws with a "flat" end
•
For proper installation of this kit, you will need to use the correct screws throughout the
process. As you disassemble your factory lid, please make note of what screws came from
where, as they will be re-used.
1. Referencing Fig. 1.2, open the factory lid and you will see 2 "T15" Torx screws on the
"bag side" of the cloth tether that holds the lid to the bag. Remove these 2 screws, move
the cloth tether out of the way, and you will see 2 more of the same screws which also
need to be removed. The lid is now free from the bag.
GASKET SEAM
STARTS HERE
4 MAIN SCREWS
Figure 1.2
FACTORY
LATCHING
MECHANISM
(SHOWN ON WHITE
LID FOR CONTRAST)
3
Advertisement
