Using The Charger; Understanding The Charger - Cushman 623526-H Owner's Manual

Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.
Provide Protection From Elements
Keep cooling fins clean and free of dirt and debris
NEMA 15 - 5R Grounded AC Receptacle
110 - 120 VAC. Dedicated 15 AMP Circuit
Locations outside the US and Canada: Reference
appropriate local electrical code and charger manu-
facturer recommendations for AC power requirements
Looping the DC cord through the steering wheel when charging serves as a good reminder to store the cord out of the way when
finished with charging. The DC plug can be damaged by driving over or catching the cord on the vehicle when driving away.
An ungrounded electrical device may become a physical hazard that could result in an electrical
shock or electrocution.

Using the Charger

The charger may remain plugged into the AC outlet when not in use. To charge the vehicle refer to the instruction
labels on the charger. Insert the polarized DC plug completely into the vehicle receptacle. The charger will automati-
cally start a few seconds after the plug is in place. The charger will automatically stop when the batteries are fully
charged and the DC plug can be removed to permit use of the vehicle.

Understanding the Charger

Plugging the charger into the vehicle's charger receptacle will lock the vehicle out of operation. When the charger is
plugged into the vehicle's charger receptacle, the charger will automatically turn on and the charger's LED and the
vehicle receptacle's LED will start flashing GREEN to indicate the batteries are charging.
Once a minimum battery voltage of 2 volts per cell (Vpc) is reached, the charger's output current will change from a
full current charge to the trickle rated charging current. The length of charge time will vary by how depleted the bat-
teries are, the input AC voltage, and/or charger ambient temperatures. The charger's LED will give a SHORT flash if
OPERATING PROCEDURES
Hanging Holes
4
Mounting Holes
4 - 5