Battery Cleaning - Cushman 623526-H Owner's Manual

Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.
The watering device should only be used if the electrolyte level is less than 1/2" (13 mm) above top of plates.
The electrolyte in a storage battery is an acid solution which can cause severe burns to the skin
and eyes. Treat all electrolyte spills to the body and eyes with extended flushing with clear water.
Contact a physician immediately.
Any electrolyte spills should be neutralized with a solution of 1/4 cup (60 ml)
sodium bicarbonate (baking soda) dissolved in 1 1/2 gallons (6 liters) of water
and flushed with water.
Always wear a safety shield or approved safety goggles when adding water or
charging batteries.

Battery Cleaning

To prevent battery damage, be sure that all battery caps are tightly installed.
To reduce the possibility of damage to vehicle or floor, neutralize acid before rinsing battery.
To reduce the possibility of damage to electrical components while cleaning, do not use a pressure washer.
Cleaning should take place per the Periodic Service Schedule.
When cleaning the outside of the batteries and terminals, do not use a water hose without first spraying the batteries
with a solution of baking soda (sodium bicarbonate) and water to neutralize any acid deposits. Use of a water hose
without first neutralizing the acid will move the acid from the top of the batteries to another area of the vehicle or stor-
age facility, where it will attack the metal structure or the concrete/asphalt floor. After hosing down the batteries, a
residue will be left on the batteries which is conductive and will contribute to the discharge of the batteries.
WATERING GUN SIMILAR TO THE TYPE INCLUDED
IN THE E-Z-GO BATTERY MAINTENANCE KIT
VALVE
CONSISTENTLY
FILLS TO A
PREDETERMINED
LEVEL
PURE WATER
ELECTROLYTE
LEVEL
Automatic Watering Gun
MAINTENANCE
SINGLE BATTERY CELL
5
5 - 17