Table of Contents
Advertisement
INSTALLATION (CONT.)
INSTALLATION
DIAGRAM
SPRING WASHER
PLAIN WASHER
TAPPING SCREW
- Only use speakers with 4 ohm impedance.
!
- Do not attach the control panel to the chassis before wiring is complete
- The maximum current of the Amp Remote trigger is 200mA.
Electrical Connections
WIRING
DIAGRAM
White:Front Left PRE-AMP Output
Radio Antenna
Red: Front Right PRE-AMP Output
Red: Rear Right PRE-AMP Outpt
White: Rear Left PRE-AMP Output
CAUTION
+12V DC
NEGATIVE
GROUND
Removal of the Main Unit
1.
Remove the metal strap from the main unit.
2.
Remove the plastic trim out from the main unit.
3.
Insert a bracket key into the left and right side of the main unit and draw the unit out of
the mounting sleeve.
HEX NUT
AUX-Left input
AUX-Right input
Rear Right Speaker
Purple/Black -
Front Right Speaker
DASH BOARD
METAL MOUNTING STRAP
CONSOLE
MOUNTING SLEEVE
Purple +
Green +
Green/Black -
Gray +
White +
Gray/Black -
White/Black -
HEX BOLT
15
Rear Left Speaker
ANT + (Blue)
Front Left Speaker
Power B + (Yellow)
ACC + (Red)
GND - (Black)
3
Advertisement
Table of Contents
