Table of Contents
Advertisement
T
3.
OOLS REPLACEMENT
a) To change tools, operate as follow :
1. Unscrew the nut then take out the screw "B".
2. Take out tools "A" with bushes.
3. Assemble the new tool.
4. Fit the screw "B" then screw the nut.
5. ATTENTION: all tools must be of the same type.
6. ATTENTION: changing type of tools you must balance again the rotor.
B
4.
ELTS ADJUSTING AND REPLACEMENT
a) To adjust the tension of the transmission belts, operate as follow :
1. Disassemble safety protection "E" unscrewing the four screws "D".
2. Unscrew the lock nut "A", screw the screw "B" to increase or unscrew to decrease the tension.
3. After operation screw the lock nut "A" then assemble the safety protection "E".
b) To change the transmission belts, operate as follow :
1. Disassemble safety protection "E" unscrewing the four screws "D".
2. Unscrew the lock nut "A" then full unscrew the screw "B"
3. Remove the old belts "E", to prevent adjusting problems you must replace both, and then assemble the
new referring to the characteristics in the SPARE PART LIST.
4. Make operations "2" and "3" point "a".
11
Advertisement
Table of Contents
