Table of Contents
Advertisement
B
1.
EFORE BEGINNING WORK
ATTENTION : the machine must be used with a tractor equipped with 4 hydraulic couplings.
a) Hook the machine to the tractor, operate as follows :
1. Remove the safety pins from the two lower connection points of the machine.
2. Plug in the raising tractor beams into the lower connection points of the machine and lock with the
safety pins.
3. Connect through tie-rod the third hitch point of the tractor with the third point of the machine (the
connection triangle vertex), insert the pin and lock with safety pin.
4. Connect the 4 hydraulic pipes to the tractor hydraulic couplings.
b) With the machine raised, go to work area.
c) Connect the tractor PTO with machine PTO.
d) Check that PTO chain is locked to prevent the protection sheet of PTO rotating.
e) Adjust the cutting height as follow :
1. Unlock the screw "A".
2. Unscrew the screw "B" then take out it.
3. Repeat the same operations on the other side of the machine.
4. Set the position of the roll "C". Moving up the roll cutting height decrease, moving it down cutting
height increase.
5. Insert then lock the screws "B", lock the screws "A".
INSTRUCTIONS FOR USE
7
Advertisement
Table of Contents
