Table of Contents
Advertisement
Problem
There are rust
stains on cutlery
Knocking noise in
the dishwasher
Rattling noise in
the dishwasher
Knocking noise in
the water pipes
The dishes
are not clean
Cloudiness on
glassware.
White spots
appear on dishes
and glasses.
Possible reason
The affected items
●
are not corrosion resistant.
A program
●
was not run after
dishwasher salt was
added. Traces of
salt have gotten
into the wash cycle.
The lid of the softer
●
is loose.
A spray arm is knocking
●
against an item in a
basket
Items of crockery
●
are loose in the
dishwasher.
This may be caused
●
by on-site installation
or the cross-section
of the piping.
The dishes were not
●
loaded correctly.
The program was
●
not powerful enough.
Not enough detergent
●
was dispensed.
Items are blocking
●
the movement of
the spray arms.
The filter combination
●
is not clean or is not
correctly fitted in the
base of wash cabinet.
This may cause the spray
arm jets to get blocked.
Combination of soft
●
water and too much
detergent.
Hard water area
●
can cause limescale
deposits.
Solution
Avoid washing items that are not
corrosion resistant in the dishwasher.
Always run a wash program
without any crockery after adding
salt. Do not select the Turbo function
(if present), after adding dishwasher
salt.
Check the softener lid is secure.
Interrupt the program and
rearrange the items which are
obstructing the spray arm.
Interrupt the program and
rearrange the items of crockery.
This has no influence on the
dishwasher function. If in doubt,
contact a qualified plumber.
See the "Preparing And Loading
Dishes".
Select a more intensive program.
Use more detergent, or change
your detergent.
Rearrange the items so that the spray
can rotate freely.
Clean and/or fit the filter correctly.
Clean the spray arm jets.
Use less detergent if you have soft
water and select a shorter cycle to
wash the glassware and to get
them clean.
Check water softener settings or fill
status of salt container.
36
Advertisement
Table of Contents
