Removing, Installing, and Replacing Components
Installing a 3½" Internal Hard Disk Drive
Your system comes with an available bay to hold an additional 3½" hard
disk drive. The drive you install must not require front panel access. The
hard disk drive access light blinks when either internal drive is active.
!
Before opening the system unit, save any open files, exit Windows, turn off
the power of the computer and all attached peripherals, and then unplug the
power cord.
1
Configure the jumpers on the new drive as a slave device (see your
drive's documentation for configuration instructions).
2
Disconnect the power cord from the computer.
3
Remove the side cover (see
"Removing the Side Cover"
37
Power connector
Jumpers
Drive connector
KY0084.VSD
on page 22).