Installing System Memory - Sony VAIO Digital Studio PCV-RX260DS Reference Manual

30
VAIO Digital Studio Reference Manual

Installing System Memory

!
Before opening the system unit, save any open files, exit Windows, turn off
the power of the computer and all attached peripherals, and then unplug the
power cord.
1
If necessary, remove the memory module you wish to replace (see
"Removing a Memory Module"
2
Remove the new memory module(s) from its anti-static package.
Hold the memory module only by its edges to prevent static-
electricity damage.
3
Choose the size of the memory module and configuration as shown
in the following table. Memory modules can vary in size and speed
between sockets. The minimum memory size is 8 MB. The maximum
memory size is 512 MB. The BIOS automatically detects the type, size
and speed of the memory modules.
Memory module configurations (MB)
DIMM1
0, 8, 16, 32, 64, 128, 256
* The PCV-RX260DS ships with 128 MB. SDRAM is expandable to 512 MB.
!
Touch any exposed metal part of the chassis to discharge static electricity in
your body before handling a memory module.
Use 100Mhz or 133 MHz FSB-supported memory (memory operates at 100MHz in either
case). Supports SDRAM memory. Does not support EDO memory or buffered DIMM
memory.
4
Disconnect the power cord from the computer.
5
Remove the side cover (see
6
Remove the power supply (see
page 41).
on page 33).
*
DIMM2
0, 8, 16, 32, 64, 128, 256
"Removing the Side Cover"
"Removing the Power Supply"
on page 22).
on