Installing a 3½" Internal Hard Disk Drive
Your system comes with an available bay to hold an additional 3½" IDE
hard disk drive. Some models, such as Configure-to-Order (CTO)
systems, may already have a second hard disk drive.
Your system can support ATA-33, ATA-66, or ATA-100 hard disk drives.
The drive you install must not require front panel access. The hard disk
drive access light blinks when either internal drive is active.
Before opening the system unit, save any open files, exit Windows, turn off
the power of the computer and all attached peripherals, and then unplug
the power cord.
Configure the jumpers on the new drive as a slave device (see your
drive's documentation for configuration instructions).
Disconnect the power cord from the computer.
Remove the side panel (see
Lift the tab adjacent to the drive holder.
Removing, Installing, and Replacing Components
"Removing the Side Panel"
Powe r c onne c tor
Jum p e rs
Drive c onne c tor
on page 22).