Advertisement
®
VALENCIA
/ VALENCIA ELITE
CONSTRUCTION REQUIREMENTS:
Floor standing models must be fixed to a nog in the wall. Wall hung models must be fixed to two nogs
in the wall. The nog size should be 50 x 75mm.
Floor standing models
TOOLS AND MATERIALS REQUIRED - (Not Supplied)
TOOLS
To suit pipework
INSTALLATION:
1. Drawer removal
(a) Open the drawer and carefully lift up on the
end of the drawer to release it from the runner
locator pins. It may be necessary to gently pry
the runner away from the drawer.
Locator pin
1223207-A02-G September 2023
®
Double Drawer Vanity
50
50mm from top of
cabinet to centre
of nog.
To suit screws
INSTALLATION INSTRUCTIONS
Wall Hung models
Positioning of the nog near
vertical centre is recommended
however exact position will
depend on plumbing etc.
MATERIALS - Not supplied & must be purchased separately
10g x 75mm
Screws (Refer step 3)
(b) The drawer is now only held by the runner
hooks at the back and can be pulled out in
the direction shown.
Page3
50mm from top of
cabinet to centre
of nog.
A height of 800 to 850mm
from the floor to the top of the
vanity top is recommended for
the wall hung vanity.
20mm
Fixing washers
Runner hook
www.englefield.co.nz
Advertisement
