Table of Contents
Advertisement
AC MAGNETO AND STARTER CLUTCH
1
2
E
3
a
2
1
2
5
3
2
www.PlanDeGraissage.org
9. Install:
• Shaft 1
• Bearing 2
• Idle gear 1 3
NOTE:
Apply the engine oil on the shaft, bearing and
idle gear inner circumference.
10. Install:
• Cover (idle gear 1) 1
• Bolt 2
NOTE:
Install the cover (idle gear 1) with its mark a
facing upward.
11. Install:
• Engine guard 1
• Clamp 2
• Bolt [engine guard (front)] 3
1
• Bolt [engine guard (rear)] 4
2
• Cylinder head breather hose 5
4
12. Connect:
• AC magneto lead
Refer to "CABLE ROUTING DIAGRAM"
section in the CHAPTER 2.
13. Install:
• Shift pedal 1
• Bolt (shift pedal)
NOTE:
When installing the shift pedal onto the shift
shaft, be sure that the center of the shift pedal
is about 1 mm (0.04 in) a above the top of the
footrest.
4 - 85
ENG
10 Nm (1.0 m · kg, 7.2 ft · lb)
23 Nm (2.3 m · kg, 17 ft · lb)
23 Nm (2.3 m · kg, 17 ft · lb)
12 Nm (1.2 m · kg, 8.7 ft · lb)
Advertisement
Table of Contents
