Table of Contents
Advertisement
TIRE PRESSURE CHECK/SPOKES INSPECTION AND
www.PlanDeGraissage.org
TIGHTENING/WHEEL INSPECTION
EC36Q000
TIRE PRESSURE CHECK
1. Measure:
NOTE:
• Check the tire while it is cold.
• Loose bead stoppers allow the tire to slip off
• A tilted tire valve stem indicates that the tire
• If the tire valve stem is found tilted, the tire is
EC36S002
SPOKES INSPECTION AND TIGHTENING
1. Inspect:
2. Tighten:
NOTE:
Be sure to retighten these spokes before and
after break-in. After a practice or a race check
spokes for looseness.
EC36T000
WHEEL INSPECTION
1. Inspect:
3 - 43
• Tire pressure
Out of specification → Adjust.
Standard tire pressure:
100 kPa (1.0 kgf/cm
its position on the rim when the tire pressure
is low.
slips off its position on the rim.
considered to be slipping off its position. Cor-
rect the tire position.
• Spokes 1
Bend/damage → Replace.
Loose spoke → Retighten.
• Spokes
3 Nm (0.3 m · kg, 2.2 ft · lb)
• Wheel runout
Elevate the wheel and turn it.
Abnormal runout → Replace.
INSP
ADJ
2
, 15 psi)
Advertisement
Table of Contents
