Table of Contents
Advertisement
3. Connect the quick connect fitting to the fuel
joint (2) until you hear the "click" while
holding the connector housing (4). Lock the
slide retainer (3) by pushing it until you hear
the "click".
If it is hard to connect, put a small amount of
engine oil on the pipe end of the fuel joint.
Injector side:
Fuel pump side:
(3)
(3)
(4)
(2)
(4)
(2) fuel joint
(3) slide retainer
(4) connector housing
4. Make sure the connection is secure and that the
slide retainer is firmly locked into place; check
visually and by pulling the connector housing.
5. Install the setting rubber (5), clamp (6) and bolt
(7) by aligning the clamp tab (8) with the
groove (9) of the stay.
Tighten the bolt securely.
(8)
(2)
(9)
(5) setting rubber
(6) clamp
(7) bolt
6. Install the fuel quick connect fitting cover (10).
Be sure the rubber cover (1) is properly installed
between the fuel quick connect fitting cover and
fuel pump.
(6)
(7)
(5)
(8) clamp tab
(9) groove
(1) rubber cover
(10) fuel quick connect fitting cover
7. Increase the fuel pressure (page 65).
Fuel System (CRF450R)
(10)
(1)
Servicing Your Honda
59
Advertisement
Table of Contents
