Package Content; Assembly And Adjustment - Black & Decker BDGL2023 Original Instructions Manual

Labels on tool
The label on your tool may include the
following symbols along with the date
code:
Hz .......
Read
Instructions
W ........
Manual
min .....
Use Eye
Protection
.....
Use Ear
Protection
.....
V ........ Volts
n .......
0
A ........ Amperes
Position of date barcode
The Date Code, which also includes the year
of manufacture, is printed into the housing.
Example:
2017 XX JN
Year of manufacturing

Package Content

This product package includes:
1 Angle grinder
1 Guard
1 Flange set
1 Spanner
1 Handle
1 Instruction manual
• Check the tool, parts, and accessories to
see if they are damaged during
transportation.
• Take a few moments to read and
understand this manual before using the
tool.
Description (Fig. 1)
Warning: Never modify the power
tool or any part of the tool, otherwise
it may cause damage to the tool or
result in personal injury.
a. ON/OFF switch
b. Spindle lock
c. Guard
......
Hertz
Class II
Construction
Watts
....
Earthing
minutes
Terminal
Alternating
....
Safety Alert
Current
Symbol
Direct
.../min.. Revolutions
Current
or Recipro-
cation per
minute
No-Load
Speed
(Original instructions)
Purpose of design
This angle grinder is designed especially for
grinding. Do not use sandpaper discs and
grinding wheels other than those with
depressed center. Do not use the tool in wet
conditions or environments in the presence
of flammable liquids or gases. This
heavy-duty angle grinder is a professional
power tool. Do not allow children to come in
contact with this tool. Inexperienced
operators are required to use this tool under
supervision.
Electrical Equipment Safety
Only one voltage is applicable to
this tool. Be sure to check that the
power suuply corresponds to the
voltage on the rating plate. Your
BLACK+DECKER tool is equipped
with double insulation, hence, it
does not require to be earthed.
When the power cord is damaged, have it
sent to a BLACK+DECKER service center for
replacement to specially prepared cables.
Using Extension Cords
If an extension cord is required, please
select a 3-phase extension cord that has
been inspected and matches the input
power (see Technical Data) of this tool. The
minimum conductor size is 1.5mm2,
maximum length is 30 meters. When using a
cable reel, be sure to pull out all the cables.

Assembly and Adjustment

Warning: To minimize the danger of
serious personal injury, please switch
o the tool power and disconnect all
plugs before adjusting or
removing/installing any accessory. Before
reassembling the tool, press and release the
trigger switch to make sure the tool is
already switched o .
Attaching and Removing the Wheel Guard
(Fig. B)
Warning To minimize the danger of
serious personal injury, please switch
o the tool power and disconnect all
plugs before adjusting or
removing/installing any accessory. Before
reassembling the tool, press and release the
trigger switch to make sure the tool is
already switched o .
ENGLISH
9