Sony EVI-HD1 Technical Manual page 6

the power of the camera by connecting it to an AC outlet
using the supplied AC power adaptor and AC power
cord, or by using the VISCA command. When you set
this switch in the standby mode, press the POWER
switch of the remote commander. This switch setting
becomes effective.
• Be sure to use a Phillips-head screwdriver when
changing the switch position. If you use a tool other than
the designated screwdriver, the crossed groove may be
damaged.
Set this arrow to the
desired video format.
Switch position Video format
0 1080i/59.94
1 1080p/29.97
2 720p/59.94
3 720p/29.97
4 NTSC (LB)
5 NTSC (CR)
6 NTSC (SQ)
7 No output
8 1080i/50
9 1080p/25
A 720p/50
B 720p/25
C PAL (LB)
D PAL (CR)
E PAL (SQ)
F No output
a: Outputs the image signal.
—: Does not output the image signal
LB: Abbreviation of LETTER BOX. A video signal
with the 16:9 aspect ratio is output by adding a blank
area (no signal, black) top and bottom to display the
image without distortion on a monitor that uses the 4:3
aspect ratio.
CR: Abbreviation of CROP. A video signal with the
4:3 aspect ratio is output, by cropping both the left and
right sides of a video image with a 16:9 aspect ratio.
SQ: Abbreviation of SQUEEZE: A video signal of the
image compressed horizontally is output so as to
display the image without distortion on a monitor with
a 16:9 aspect ratio.
HD OUT SD OUT
a —
a —
a —
a —
— a
— a
a
—
— —
a —
a —
a —
a —
— a
— a
— a
— —
7 VISCA IN connector
8 VISCA OUT connector
9 SD OUT VIDEO connector
0 SD OUT S VIDEO connector
qa HD OUT COMPONENT connector
Pin No. Function
At YPbPr COMPONENT At YPbPr COMPONENT
setting (at SYNC)
0 Pr-OUT
1 Y-OUT
2 Pb-OUT
3 GND
4 GND
5 GND
6 GND
7 GND
8 GND
9 No connection
10 GND
11 GND
12 No connection
13 HD-OUT
14 Tri-level SYNC-OUT
15 No connection
qs HD OUT HD-SDI connector
qd IR SELECT switch
qf BOTTOM switches
1 Switch 1 (infrared remote commander signal
output switch)
Set to ON to enable output of the infrared signals, that
are transmitted from the Remote Commander, from the
VISCA IN connector, or set it to OFF to disable the
output.
Note
Set IR ON/OFF before turning on the power. If you set
IR ON/OFF after turning on the power, the setting is
ignored.
Locations of Controls
setting (at VD)
Pr-OUT
Y-OUT
Pb-OUT
GND
GND
GND
GND
GND
GND
No connection
GND
GND
No connection
HD-OUT
Bi-level VD-OUT
No connection
6