Table of Contents
Advertisement
Altering an option or a running programme
It is possible to change some options before the programme carries them out. Before you
make any change, you must pause the washing machine by pressing the button 8 .
Changing a running programme is possible only by resetting it . Turn the programme
selector dial to
pressing the 8 button again. The washing water in the tub will not emptied out.
Interrupting a programme
Press the button 8 to interrupt a programme which is running, the corresponding light
starts blinking. Press the button again to restart the programme.
Cancelling a programme
Turn the selector dial to
a new programme.
Opening the door after the programme has started
When the machine is working and through the delay time, the door is locked. If, for any
reason, it is necessary to open it, set firstly the machine to pause by pressing the button
8 . If the symbol 7.5 after a few minutes goes off, the door can be opened.
If the symbol 7.5 stays on and the door remains locked, this means that the machine is
already heating or that the water level is too high. In this case the door can not be opened.
If you cannot open the door but you need to open it you have to switch the machine off
by turning the selector dial to
attention to the water level and temperature !) .
After closing the door, it is necessary to select the programme and options again and to
press button 8 .
At the end of the programme
The machine stops automatically, the pilot light of button 8 and the symbol 7.5 goes off
and a blinking
opened.
If a programme or an option that ends with water still in the tub has been selected, a
will appear on the display, the pilot light of button 8 goes off and the door
blinking
remains locked to indicate that the water must be emptied out before opening the door.
Follow the below instructions to empty out the water:
• Turn the programme selector dial to
• Select the draining or spinning programme
• Reduce the spin speed, if needed, by pressing the relevant button
• Press button 8 to start the programme
• When the programme has finished the display shows a blinking
off and the door can be opened.
Turn the programme selector dial to
from the drum and carefully check that the drum is empty. If you do not intend to carry
out another wash, close the water tap. Leave the door open to prevent the formation of
mildew and unpleasant smells.
and then to the new programme position. Start the new programme by
to cancel a programme which is running. Now you can select
. After a few minutes the door can be opened (pay
will appear on the display. Some acoustic signals sound. The door can be
to switch the machine off. Remove the laundry
13
Daily use
. The symbol 7.5 goes
Advertisement
Table of Contents
