Table of Contents
Advertisement
6. Select the Delay Start
Before you start the programme, if you wish to delay
the start, press the Delay Start button repeatedly, to
select the desired delay. The relevant light illuminates.
12 H
8 H
Delay
Start
4 H
2 H
Washing
End
7. Start the programme
Before starting up the machine check that:
the appliance is plugged in
the water supply tap is turned on
the drain hose is correctly and securely positioned
the door and the detergent dispenser drawer are
closed.
To start the selected programme, press the Start/Pause
button; the corresponding light stops flashing.
The "Washing" light illuminates.
The machine starts operating.
Start/
Pause
If you have chosen a delayed start, the machine will
begin the countdown.
8. Altering an option or a
running programme
It is possible to change any option before the
programme carries it out.
Before you make any change, you must pause the
washing machine by pressing the Start/Pause button.
Changing a running programme is possible only by
resetting it. Turn the programme selector dial to "O"
and then to the new programme position.
Start the new programme by depressing the Start pause
button. The washing water in the tub will not emptied
out .
9. Interrupting a programme
Depress the Start/Pause button to interrupt a programme
which is running, the corresponding light starts to flash.
Depress the button again to restart the programme.
10.Cancelling a programme
Turn the selector dial to O to cancel a programme which
is running. Now you can select a new programme.
11.Opening the door after the
programme has started
First set the machine to PAUSE by pressing the
Start/Pause button.
If the door does not open in 2 minutes, this means that
the machine is already heating, that the water level is
above the bottom edge of the door or that the drum is
turning.
If you cannot open the door but you need to open it you
have to switch the machine off by turning the selector dial
to "O". After about 2 minutes the door can be opened
(pay attention to the water level and temperature!).
12. At the end of the programme
The machine stops automatically.
If the RINSE HOLD option has been selected, the
"start pause" light goes off, the phase light "End"
illuminates and the door is blocked to indicate that the
water must be emptied out before opening the door.
To do this first turn the programme selector dial to "O"
and then to drain programme
Reduce the spin speed if needed, by using the spin
speed selector dial.
Release of the lock is also indicated by the coming on of
the "End" light.
Turn the programme selector dial to "O" to switch the
machine off. Remove the laundry from the drum and
carefully check that the drum is empty.
If you do not intend to carry out another wash, close the
water tap. Leave the door open to prevent the formation
of mildew and unpleasant smells.
10
or spin programme
Advertisement
Table of Contents
