Maintenance And Cleaning; General Cleaning Information - Beko BHCA92442BBH User Manual

If you run your hood at any speed
level with the aluminium filter fill
warning, the warning will not ap-
pear for as long as the hood is run-
ning. When you turn off the hood,
the fill warning starts flashing
again.
If you turn off the warning without
cleaning the aluminium filter, the
operating time of 100 hours is re-
set and it starts over. At the end of
the next 100 hours, your hood
warns again.
Carbon filter fill warning (for products with
carbon filter)
The light of Speed 2 key flashes after every
100 hours of operation. In this case, you
must replace your carbon filter. Consult an
authorized service for this. After replace-
ment, the lamp warning of Speed 2 key
does not turn off automatically. When you

5 Maintenance and Cleaning

5.1 General Cleaning Information

General warnings
• Service life of the product extends and
frequently faced problems decrease if
cleaned at regular intervals.
• Disconnect the product from the elec-
trical connection before starting main-
tenance and cleaning operations. There
is an electric shock hazard!
• Some detergents or cleaning agents may
cause damage to the surface. Do not use
abrasive detergents, cleaning powders,
cleaning creams or sharp objects during
cleaning.
• Do not use steam cleaning products for
cleaning.
touch the Speed 2 key for more than 3
seconds, carbon filter fill warning is reset
and the lamp is turned off.
The warning is not cancelled if the
power is cut when the hood gives
carbon filter fill warning. When the
power is available, it continues to
warn with the light of Speed 2 key
flashing.
If you run your hood at any speed
level with the carbon filter fill warn-
ing, the warning will not appear for
as long as the hood is running.
When you turn off the hood, the fill
warning starts flashing again.
If you turn off the warning without
replacing the carbon filter, the op-
erating time of 100 hours is reset
and it starts over. At the end of the
next 100 hours, warning is given
again.
Product cleaning
• The product should be thoroughly
cleaned after each use. Thus, food
residues are easily cleaned and these
residues are prevented from burning
when the product is used again later.
• No special cleaning agent is required for
cleaning the product. Clean the product
using dishwashing detergent, warm wa-
ter and a soft cloth or sponge and dry it
with a dry cloth.
• Do not use acid or chlorine-containing
cleaning agents to clean stainless or
inox surfaces and handles. Clean with a
soft soapy cloth and liquid (non-scratch-
ing) detergent, taking care to wipe in one
direction.
• There are sensors in the backside of the
product's glass cover. Do not damage
these sensors during cleaning. (For
model C)
EN / 16