Beko BHCA92442BBH User Manual page 15

If the ambient temperature differ-
ence occurs even when the hob is
not operating while the automatic
mode is active, the temperature
sensor in the product will detect
the difference and the product may
start operating at Speed 2 or 3 de-
pending on the difference. In this
case, automatic mode will be
turned off when the temperature
difference is equalized.
Do not use automatic mode when
your hob is not working.
Air cleaning mode (for models B and C)
You can use air cleaning mode to eliminate
the odour in your house during a long time
at low level.
1. Touch the Speed 1 key for more than 3
seconds.
ð Air cleaning mode is activated.
The light of the Speed 1 key
flashes when the air cleaning
mode is active.
2. The air cleaning mode will operate at
Speed 1 for 10 minutes in 1 hour and
will stop for 50 minutes. If you do not
switch off the air cleaning mode, it will
remain in operation for 10 minutes, then
stop for 50 minutes in each hour for 24
hours.
When air cleaning mode is active, it
is automatically cancelled at the
touch of any key except lamp key.
Your hood continues to operate at
the function of the key you touch.
Hood and hob combined working (Hob to
Hood function – for model B)
If your hob has a hob-hood combined op-
eration feature (Hob to Hood), Model B
product can work with the hob. You can
use this feature for the model B hood by
following the descriptions in the hob
manual.
Things to consider when using the "Hob
to Hood" function:
• If the pot is positioned in the right front
eye of the hob in such a way that the
view angle of the sensor is blocked, the
hood's "Hob to Hood" function may not
work.
• Do not use an object that will cover the
hood control panel. Remove this object
and operate your product.
• Do not block the signal between the hob
and the hood (with a cover, oven cloth,
long pot). In such a case, remove the
obstacle and restart your hob.
• The sensor locations in a hob and hood
are indicated schematically in the image
below. Do not place any objects that will
block the signal in between.
Aluminium filter fill warning
The light of Speed 2 key flashes after every
100 hours of operation. In this case, you
must clean your aluminium filter. After
cleaning, the lamp warning of Speed 2 key
does not turn off automatically. When you
touch the Speed 2 key for more than 3
seconds, aluminium filter fill warning is re-
set and the lamp is turned off.
The warning is not cancelled if the
power is cut when the hood gives
aluminium filter fill warning. When
the power is available, it continues
to warn with the light of Speed 2
key flashing.
EN / 15
EN
FR