Thermann Owner’s Guide Gas Continuous Flow Water Heaters IMPORTANT SAFETY INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONS 1. Do not hang washing or other materials adjacent to the unit. 2. Do not use or store flammable materials within 2 metres of the unit.
Page 5
IMPORTANT SAFETY INSTRUCTIONS MEASURES TO BE TAKEN DURING ELECTRICAL STORMS Power surges caused by lightning can cause damage to the electrical components of the unit. Turn off the main power during electrical storms. DO NOT INSTALL INDOORS Danger This unit is designed for outdoor installation. Never install indoors. It will be extremely dangerous because it will cause oxygen deficiency and incomplete combustion.
Page 6
Thermann Owner’s Guide Gas Continuous Flow Water Heaters IMPORTANT SAFETY INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONS DO NOT DISASSEMBLE, REPAIR OR MODIFY Warning Do not disassemble or modify the units as this may cause fire, electric shock and other accidents.
Caution IMPORTANT SAFETY INSTRUCTIONS Caution MEASURES TO BE TAKEN IN CASE OF EMERGENCY The procedure to follow in an emergency such as earthquake, flood or fire is: Close 1. Close all hot water taps in the house. Close 2. Close the gas valve and the main water valve. 3.
Gas Continuous Flow Water Heaters REMOTE CONTROLLER Up to three remote controllers are able to be installed with your Thermann unit for complete control of your hot water. Please note, units without remote controller will be set at either 50°C or 60°C (the exception is if the unit is installed as a solar booster.
Page 9
REMOTE CONTROLLER Operation of Remote Controller Please read these instructions carefully before using this appliance. 1. Turn on the ON/OFF button. 2. The temperature display will read 40°C. 3. The priority indicator will illuminate. 4. Select hot water temperature by pushing button on the remote controller.
Page 10
Thermann Owner’s Guide Gas Continuous Flow Water Heaters REMOTE CONTROLLER Priority Control (Change) The temperature can only be controlled by the remote controller which has the priority indication. When the priority button is turned ON, that controller takes priority control over the temperature settings.
INDICATOR. The cause of the fault can be determined after checking the fault numbers display on the Status Display of the THERMANN HOT WATER UNIT and the remote controller display. Check the monitor whilst hot water taps are closed. STATUS DISPLAY...
Page 12
Thermann Owner’s Guide Gas Continuous Flow Water Heaters FAULT MONITOR DISPLAY PROBLEM REMEDY REMOTE STATUS CONTROLLER DISPLAY GAS BURNER FAILS TO IGNITE CHECK GAS SUPPLY CHECK GAS SUPPLY LOSS OF COMBUSTION AND PRESSURE CALL REECE CUSTOMER CARE THERMAL FUSE FAILURE...
WARRANTY This warranty will apply only under all of the following conditions: • The item has been installed by a licensed plumber • Failure is due to a fault in the manufacture of the product • Proof of purchase (including the date of purchase) is provided •...
Page 14
Up to 200 mg/litre or ppm Warranty Terms Thermann Gas Continuous Flow Hot Water Units are covered by Reece for any cost of labour and parts in the event of a component failure due to any defects that may arise either from workmanship and/or faulty material.
Need help?
Do you have a question about the G16NG50 and is the answer not in the manual?
Questions and answers