Australia And New Zealand Regulatory Compliance; Approved Antennas - u-blox JODY-W2 System Integration Manual

5.8 Australia and New Zealand regulatory compliance

JODY-W2 series modules are compliant with the Australian/New Zealand Industry
Standard "AS/NZS 4268:2012/AMDT 1:2013 Radio equipment and systems –
Short range devices – Limits and methods of standard measurement". The
standard is developed and maintained by the Australian Communications and
Media Authority (ACMA).
JODY-W2 module test reports can be used to partly demonstrate that the application product meets
the necessary performance requirements for using the Regulatory Compliance Mark (RCM). To
satisfy the overall Australian and/or New Zealand compliance requirements on the end product, the
integrator must create a compliance folder that contains all relevant compliance test reports.
For more information about Australian compliance, visit the Australian Communications and Media
Authority web site http://www.acma.gov.au/.
For more information about New Zealand compliance, visit the New Zealand Radio Spectrum
Management Group web site www.rsm.govt.nz.

5.9 Approved antennas

Refer to the JODY-W2 antenna reference design application note
must be fulfilled in the end product that uses radio type approval of the JODY-W2 module. The JODY-
W2 antenna reference design application note provides PCB layout details and electrical
specifications.
For Bluetooth and Wi-Fi operation in the 2.4 GHz band and Wi-Fi operation in the 5 GHz band,
JODY-W2 has been tested and approved for use with the antennas listed in
Manufacturer Part number
Linx ANT-DB1-RAF-RPS
[22]
Linx ANT-2.4-CW-RCT-RP
[23]
Table 37: List of approved antennas
⚠
For compliance with FCC §15.407(a), the EIRP is not allowed to exceed 125 mW (21 dBm) at any
elevation angle above 30° (measured from the horizon) when operated as an outdoor access point
in U-NII-1 band, 5.150-5.250 GHz.
UBX-18068879 - R14
C1 - Public
Antenna type
Dual-band dipole antenna
Single-band dipole antenna
Regulatory compliance
JODY-W2 - System integration manual
[15] for the specifications that
Table
Peak gain [dBi] / band Validated regulatory
domain
2.4 GHz 5 GHz
2.5 4.6 FCC/ISED, ETSI, ACMA,
NCC, KCC, Giteki
2.2 - FCC/ISED, ETSI, ACMA,
NCC, KCC, Giteki
37.
Page 72 of 84