Table of Contents
Advertisement
4 Qualifications and Approvals
The ODIN-W2 series modules are in Advance Information status as mentioned in Document status
explanation section. Hence, the following information is not fully valid and completed yet but will
be when the module is fully tested and approved in the Production Information stage as
mentioned in the Document status section:
•
Safety Compliance
•
FCC and IC Compliance
•
Japan Radio Equipment Compliance
The required action needed by the module integrator is described in this chapter. For a complete description of
the qualifications and approvals see the ODIN-W2 series Data Sheet [2].
4.1
Safety Compliance
In order to fulfill the safety standard EN 60950-1 the unit must be supplied by a limited power source.
4.2 FCC and IC compliance - Labeling Requirements for End Product
The ODIN-W2 series modules are in Advance Information status as mentioned in Document status
explanation section. Hence, the following information is not fully valid and completed yet but will
be when the module is fully tested and approved in the Production Information stage as
mentioned in the Document status section:
For an end product using the product cB-0965 there must be a label containing, at least, the following
information:
This device contains
FCC ID: PVH0965
IC: 5325A-0965
The label must be affixed on an exterior surface of the end product such that it will be visible upon inspection in
compliance with the modular approval guidelines developed by the FCC.
In accordance with 47 CFR § 15.19 the end product shall bear the following statement in a conspicuous location
on the device:
"This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions;
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation."
When the device is so small or for such use that it is not practicable to place the statement above on it, the
information shall be placed in a prominent location in the instruction manual or pamphlet supplied to the user
or, alternatively, shall be placed on the container in which the device is marketed. However, the FCC ID label
must be displayed on the device.
In case, where the final product will be installed in locations where the end-user is not able to see the FCC ID
and/or this statement, the FCC ID and the statement shall also be included in the end-product manual.
UBX-14040040 - R03
ODIN-W2 series - System Integration Manual
Advance Information
Qualifications and Approvals
Page 24 of 33
Advertisement
Table of Contents
