Displays And Configurations Of The On-Board Computer - Bosch Purion BUI215 Original Operating Instructions

Displays and configurations of the on-board computer

Battery charge indicator of the eBike
battery
The battery charge indicator (g) displays the eBike
battery's state of charge. The eBike rechargeable bat-
tery's state of charge is also indicated by the LEDs on
the eBike rechargeable battery itself.
Each bar of the battery symbol on the indicator (g)
represents approximately 20 % of the capacity:
The eBike battery is fully charged.
The eBike battery should be recharged.
The LEDs of the battery charge indicator on
the eBike battery go out. The capacity for as-
sisting the drive has been used up, and assis-
tance is gently switched off. The remaining
capacity is made available for the lighting.
The indicator flashes.
The capacity of the eBike battery is enough
for about 2 hours of lighting.
If an eBike is powered by two eBike batteries, the
eBike battery charge indicator (g) displays the state
of charge of both eBike batteries.
Bosch eBike Systems
Speed and distance indicators
(j)
(i)
(h)
The speedometer (a) always displays the current
speed.
The indicator (i) always displays the last setting as
standard. Repeated medium-length presses of the
button – will display the trip distance TRIP, the total
distance TOTAL and the battery range RANGE one af-
ter the other. (Briefly pressing the button – will de-
crease the assistance level.)
To reset the trip distance TRIP, select the trip dis-
tance TRIP and simultaneously press and hold the
buttons + and –. The display will initially show RE-
SET. If you continue to press both buttons, the trip
distance TRIP will be set to 0.
To reset the battery range RANGE, select the battery
range RANGE and simultaneously press and hold
the buttons + and –. The display will initially show RE-
SET. If you continue to press both buttons, the
range RANGE will be reset to the value of the factory
setting.
You can switch the displayed values from kilometers
to miles by holding down the button – and briefly
pressing the on/off button (1).
The versions of the subsystems and their model part
numbers can be displayed for servicing purposes,
provided the subsystems divulge this information
(dependent on the subsystem). With the system
switched off, simultaneously press the buttons –
and + and then press the on/off button (1).
English – 11
(a)
(b)
(c)
(d)
(e)
(g) (f)
1 270 U20 XBP | (14.03.2023)