Advertisement
Dishes not dry
Clouding of glassware
Water marks on some items
or on plastic dishes
Removable streaks on
glasses, metal items and
cutlery
Food residues on the dishes
User instructions
No rinse aid
A program has been used that
does not involve a final drying
cycle
Water in dishes or pans
The dishes were taken out too
soon
Use of ecological rinse aids
Plastic dishes
The combined detergent used
does not produce good drying
results
Glass not dishwasher safe
The formation of drops on the
plastic parts is inevitable;
stains may therefore be visible
after drying
Too much rinse aid
No rinse aid or setting too low
Detergent not very effective
Dishes too close together,
baskets too full
The spray arms do not rotate
Clogged spray arm nozzles
Add rinse aid
See program table
When loading the dishwasher,
make sure that you place
dishes and pans at an angle
Wait at least 20 minutes after
the end of the program
Ecological products may be
less effective than traditional
products
Plastic has a lower heat
storage capacity and is
therefore harder to dry
Use a different combined
detergent. Using traditional
rinse aids improves drying.
Only use glassware that is
dishwasher safe. Check the
water softener setting (reduce
if necessary). Use a detergent
that contains additives for
protecting glass
Use a more intense program
Arrange dishes at an angle so
that the water can drain off
easily
Use a traditional rinse aid or
increase the dosage
Increase the water softener
setting
Reduce the amount of rinse
aid
Add rinse aid or increase
supply
Packets of detergent should
not be kept open for too long.
The detergent loses
effectiveness
There must always be enough
space between the dishes to
allow water jets to pass. Avoid
contact points
Take care not to prevent the
spray arms from rotating when
loading the dishwasher
Clean the spray arms as
indicated in the manual
58
Advertisement
Troubleshooting
