Advertisement
2.2 General information
Remove the polystyrene basket retainers.
Position the appliance in the desired place of installation.
This appliance may be placed up against walls or other
furniture units.
If the appliance is installed near a heat source, fit a
special insulating panel to prevent overheating and
malfunction of the appliance.
To ensure stability, install integrated or built-under
dishwashers only under continuous worktops, and screw
them to the adjacent units.
To facilitate the installation procedure, the intake and
drain hoses can be positioned in any direction; make
sure that the hoses are not kinked, crushed or pulled too
tightly.
A hole at least 8 cm in diameter is required to allow the
power supply cable and hoses to pass.
At the end of the installation, perform a short test of the
appliance: open the water tap and check that there are
no leaks.
To install the dishwasher against the back wall, the
hoses should be passed through the lower area where
there is a dedicated space for them.
The following spare parts will be available for 7 years
after the model is no longer produced: wash pump,
drain pump, heating elements; pipes and hoses, valves,
filters and acquastop devices; structural and internal
parts of the door (separately or as an assembly);
Installation
10
Advertisement
Troubleshooting
