IBC SL 30-175 Installation And Operating Instructions Manual page 41

NOTE
The safety warning regarding
burner refractory on page
4-2 of this manual must be
observed.
Heat Exchanger Lid
Heat Exchanger Lid Hex Nuts
Heat Exchanger Gasket
Combustion Chamber Refractory
Heat Exchanger revealed
STARTUP AND COMMISSIONING
SL 30-175 MODULATING GAS BOILER
3.4.1 Gaining access to combustion chamber, burner
removal instructions
1. Remove fan and gas valve assembly. See "Fan and gas valve removal
instructions" on page 4-6 of this manual.
2. Disconnect the igniter cable, gas valve cable and 2 fan plugs and move them
out of the way.
3. Remove the two screws that secure the igniter to the lid using a # 2 Phillips
screwdriver.
Carefully remove the igniter by sliding it straight up.
4.
Remove the igniter gasket and place parts on a clean dry area.
5.
6. Remove the 6 hex nuts that attach the heat exchanger lid to the heat
exchanger. A 10 mm open end wrench or socket will be required.
With a permanent marker or equivalent, make an alignment mark between
7.
the lid, gasket and heat exchanger.
Before removing the lid, it is important to be positioned directly above it to ensure
8.
a straight up extraction. Failing to do this may result in refractory damage.
Slowly lift the lid-burner assembly off the heat exchanger. The refractory
9.
should remain in place in the combustion chamber shoulder. Note that
there is less than 1/8" (3 mm) clearance between the burner walls and the
refractory. Care must be observed to ensure minimal contact between these
parts to prevent refractory cracking.
10. Place the lid with the burner attached, on a clean dry area.
With a permanent marker or equivalent, make an alignment mark on the
11.
refractory lining it up with the same mark made earlier between the lid and
heat exchanger.
Carefully remove the refractory and place in a clean dry area.
12.
13. If burner needs to be removed, gradually loosen up the 3 screws that secure
the burner to the heat exchanger lid using a #2 Phillips screwdriver. Remove
screws and burner.
RE-ASSEMBLY
1. Inspect burner gasket. Look for cracks, deterioration or signs of gas bypass.
Replace if necessary.
Place heat exchanger lid on a flat surface and position the gasket on the lid,
2.
aligning it with the screw holes.
Install the burner in place with its 4 screws, tightening the screws gradually and
3.
in a cross sequence. Do not over tighten, hand tight plus 1/8 turn should be
sufficient to maintain a good seal and prevent deformation of the burner flange.
Inspect refractory for cracks, degradation and flatness. If in doubt, replace
4.
with a new one.
If installing a new refractory, first place it onto the lid, aligning it at the igniter
5.
hole, then make an alignment mark on the refractory to coincide with the
previously made line on the lid.
Carefully insert refractory into heat exchanger combustion chamber, using
6.
the alignment marks for proper positioning.
Ensure that the lid (orange) gasket is in good condition and is in place and flat.
7.
8. Carefully insert the lid-burner assembly straight down ensuring limited contact
between burner and refractory and observing the alignment markings.
9. Install the 6 hex nuts to secure the lid in place, tighten by hand, then an extra
1/2 to 1 turn. Caution! Over-tightening these nuts will cause lid to warp and
possibly leak fumes or flames.
10. Re-install igniter, tightening its screws by hand, then an extra 1/8 turn.
Re-attach igniter wire to igniter, gas vlave cable and the 2 fan plugs.
11.
3-5