Table of Contents
Advertisement
Chapter 5 — Printer Maintenance
30
5 Disconnect the printhead cable (item 2) from the rear of the printhead (item
1).
To install
1 Connect the printhead cable to the rear of the printhead (item1).
2 Position the printhead into the printhead carrier (item 2). Be sure the two
screw heads on the printhead are located into the holes (item 5) of the
printhead carrier.
3 While pressing down on the printhead carrier, install and tighten the
printhead screw (item 3) using a Phillips screwdriver (item 4).
4 It is now recommended to clean the printhead to remove any oil or dirt from
handling. Perform the
"Clean the Printhead" on page
MP Compact4 Mark III User Guide
27.
Advertisement
Table of Contents
