Setup; Fluid And Work Piece Preparation; Fluid Set Selection - Graco 17P481 Operation - Repair - Parts

Setup

Fluid and Work Piece
Preparation
•
Strain fluids before spraying. This
includes colors, reducers and
hardeners.
•
Use a slower drying reducer or thinner to
compensate for the faster drying time
caused by the warm air of the turbine. Do
not over reduce.
•
Spray performance varies with the
viscosity of the material sprayed, HVLP
sprayer, and length of hose.
FLUID SET SELECTION GUIDE
Material
Dye
Ink
Non-wiping Stain
Automotive Finish
Lacquer
Stain
Enamel
Epoxy
Urethane
Varnish
Primer
Industrial Finishes
Latex
Multi-Spec
Butyrate
Nitrate Dope
Oil Wall Paint
3A4980B
Fluid Set #2 Fluid Set #3
17P485 17P486
•
Most material manufacturers provide
recommendations for their materials.
Follow these recommendations.
•
For proper adhesion, ensure surface of
work piece is completely clean.

Fluid Set Selection

For best spray performance, select proper
fluid set for fluid being sprayed. Reference
the Fluid Set Selection Guide for the fluid
set recommended for your application. Fluid
set numbers are marked on fluid needles and
nozzles.
Fluid Set #4 Fluid Set #5
17P487 17P488
Setup
Fluid Set #6 Fluid Set #7
17P489 17P490
ti30938a
9