Table of Contents
Advertisement
Available languages
Available languages
2. Attach one adapter to the gas pressure regulator and the
other adapter to the gas shutoff valve. Tighten both adapters,
being certain not to move or turn the gas pressure regulator.
3. Use a 15/16" (2.4 cm) combination wrench and an adjustable
wrench to attach the flexible connector to the adapters.
IMPORTANT: All connections must be wrench-tightened. Do
not make connections to the gas regulator too tight. Making
the connections too tight may crack the regulator and cause a
gas leak. Do not allow the regulator to turn when tightening
fittings.
A. 1/2" (1.3 cm) or 3/4" (1.9 cm)
gas pipe
B. Use pipe-joint compound
C. Adapter
D. Manual gas shutoff valve
Complete Connection
1. Open the manual shutoff valve in the gas supply line. The
valve is open when the handle is parallel to the gas pipe.
A.
Closed Valve
B.
Open Valve
2. Test all connections by brushing on an approved noncorrosive
leak-detection solution. If bubbles appear, a leak is indicated.
Correct any leak found.
3. Remove cooktop burner caps and bases from package
containing parts. Place the burner bases as indicated below:
A. Small (Auxiliary)
C. Oval (OV)
B. X-Large (Stack)
20
E. Flexible connector
F.
Adapter (must have 1/2"
[1.3 cm] male pipe thread)
G. Use pipe-joint compound
H. Gas pressure regulator
D. Medium (Semi
Rapid)
E. Large
(UltraRapid)
NOTE: Each round burner base is marked with one of the
following: AUX, SR, UR, or ST.
4. Align the gas tube opening in the burner base with the orifice
holder on the cooktop and the igniter electrode with the notch
in the burner base.
A.
Burner cap
B.
Gas tube
opening
C.
Burner base
5. Place the burner caps on the appropriate burner bases.
NOTE: The bottom of the small and medium caps are
different. Do not put the wrong size burner cap on the burner
base. Each round burner cap is marked with an AUX, SR, UR,
or ST to match with a letter on the burner base.
Medium cap
Small cap
(Semi Rapid)
(Auxiliary)
Burner caps should be level when properly positioned. If
burner caps are not properly positioned, surface burners will
not light. The burner cap should not rock or wobble when
properly aligned.
6. Place burner grates over burners and caps.
7. Plug into appropriate outlet. See the appropriate "Electrical
Requirements" section.
8. Turn on power.
D. Igniter electrode
E. Orifice holder
Large cap
X-Large cap
(Ultra Rapid)
(Stack)
A.
Incorrect
B.
Correct
Advertisement
Table of Contents
