Table of Contents
Advertisement
Installing the Siphon Kit
See the Siphon Kit, Model 238250, Parts List on page
15.
1. Remove the top plug (5) and the bottom plug (20).
2. Replace the bottom plug (20) with the plain bearing
(53), and tighten the bearing with a wrench.
3. Work the PTFE o-ring (54) onto the siphon tube
retainer (51), and press it into the o-ring groove.
4. Replace the top plug (5) with the siphon tube
retainer (51). Leave the retaining nut (52) on the
siphon tube retainer, but make sure it is not
tightened. Tighten the siphon tube retainer into the
top of the agitator housing with a wrench.
5. Slide the siphon tube (50) down through the retaining
nut (52), siphon tube retainer (51), and agitator shaft
(6) until the siphon tube touches the bottom of the
drum. Raise the siphon tube approximately 1/4 in.
(approximately 6 mm) so that it does not touch the
bottom of the drum. Hold the siphon tube at this
height with one hand, and tighten the retaining nut
with the other hand (hand-tight is enough to hold the
siphon tube in place).
CAUTION
Barrel Heights Vary.
Loosen the retaining nut on the siphon tube retainer
before you raise the drum cover. If you do not loosen
the retaining nut, the siphon tube may make contact
with the bottom of the barrel when you lower the drum
cover onto a new barrel, which could damage the
siphon tube or the barrel.
6 308609
Installation
50
52
1
51
54
Make sure the center tabs on the retaining nut
1
ferrule point down.
Fig. 3
5
6
53
20
05736B
Advertisement
Table of Contents
