Sharp XV-Z30000 Operation Manual page 21

4. Adjust the angle
Adjust the projector angle:
• Shift the lens horizontally and vertically.
1
Press H&V SHIFT on the remote control.
2
Press P, R, O or Q on the remote control.
• Adjust the projector angle by rotating the
adjustment feet.
5. Adjust the focus and the zoom
1
Press FOCUS +/– on the remote control to adjust the focus.
2
Press ZOOM +/– on the remote control to adjust the zoom.
6. Correcting the image distortion due to the projection angle
1
Press KEYSTONE on the projector or on the remote control.
2
Press ENTER on the projector or on the remote control.
3
Press P, R, O or Q to move the position for the upper left of the image.
4
Press ENTER to set the position.
5
Repeat the same procedure with the positions for the upper right, lower right and lower
left of the image.
• When the position of the lower left is set, the correction is
made and the display disappears.
7. Select the Input mode
On the projector:
Press INPUT R/P to display the INPUT list. Use INPUT R/P to select the input mode.
INPUT list
INPUT
HDMI1
HDMI2
COMPUTER
COMPONENT
On the remote control:
Press HDMI 1/2, COMPONENT or COMPUTER to
select the input mode.
8. Turn the power off
Press STANDBY/ON on the projector or STANDBY on the remote control, and then press
the button again while the confi rmation message is displayed to put the projector into
Standby mode.
On the
projector
On-screen display (HDMI1)
On the remote
control
HDMI1
YPbPr
1080P
On-screen display
PP. 29, 30
P. 30
P. 31
P. 35
P. 28
19