Table of Contents
Advertisement
3. Replace the two (M2x5) screws that secure the network-port bracket to the I/O board.
1. Install the
base
cover.
2. Follow the procedure in
I/O board
Removing the I/O board
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the
network-port
The following images indicate the location of the I/O board and provide a visual representation of the removal procedure.
1. Remove the three (M2.5x4.5) screws that secure the left hinge to the palm-rest and keyboard assembly.
2. Open the display hinge at an angle of 90 degrees.
3. Open the latch, and disconnect the power button with optional fingerprint reader cable from the I/O board.
4. Disconnect the coin-cell battery cable from the I/O board.
5. Peel the tape that secures the I/O-board cable to the I/O board.
6. Open the latch and disconnect the I/O-board cable from the I/O board.
7. Remove the screw (M2x2) that secures the I/O board to the palm-rest and keyboard assembly.
8. Lift the I/O board off the palm-rest and keyboard assembly.
Installing the I/O board
If you are replacing a component, remove the existing component before performing the installation procedure.
The following image indicates the location of the I/O board and provides a visual representation of the installation procedure.
40
Removing and installing components
After working inside your
Before working inside your
bracket.
computer.
computer.
Advertisement
Table of Contents
