Table of Contents
Advertisement
1. Slide the touchpad into the slot on the palm-rest and keyboard assembly.
NOTE:
Turn the computer over and open the display. Ensure that the touchpad is equally aligned along all four sides.
2. Replace the two (M2x1.8) screws that secure the touchpad to the palm-rest and keyboard assembly.
3. Adhere the tapes that secure the touchpad to the palm-rest and keyboard assembly.
4. Align the screw holes on the touchpad bracket with the screw holes on the palm-rest and keyboard assembly.
5. Replace the three (M1.6x2) screws that secure the touchpad bracket to the palm-rest and keyboard assembly.
6. Adhere the tape that secures the touchpad bracket to the palm-rest and keyboard assembly.
7. Slide the touchpad cable into the connector on the touchpad and close the latch to secure the cable.
1. Install the
3-cell battery
2. Install the
base
cover.
3. Follow the procedure in
Display assembly
Removing the display assembly
1. Follow the procedure in
2. Remove the
base
cover.
The following images indicate the location of the display assembly and provide a visual representation of the removal procedure.
or
4-cell
battery, whichever applicable.
After working inside your
Before working inside your
computer.
computer.
Removing and installing components
45
Advertisement
Table of Contents
