Cleaning And Maintenance - BOMANN GSP 861 Instruction Manual

Household dishwasher

Hide thumbs

Table Of Contents

Table of Contents

• To do a program change, press the Start/Pause

button for more than 3 seconds.

• Select a new program and start the new opera-

tion.

Forgot to add a dish?

WARNING:

Open the door very carefully during operation, there

is a risk of water squirting out.

Dishware can be added any time before the deter-

gent dispenser opens.

• Press the Start/Pause button to stop the opera-

tion. Once the spray arms have stopped, you can

fully open the appliance door.

• Add forgotten dishware.

• Press the Start/Pause button, the operation will

continue after approx. 10 seconds.

At the e

At the end of program

At the e

nd of program

CAUTION:

Allow the appliance to cool down a bit after the pro-

gram has ended, before you open it. This avoids that

steam escapes that causing long-term damages to

your furniture.

At the end of the rinse cycle will sound a series of

signals; then the unit goes into standby mode.

Turn off

Turn

off

Turn

off

• Turn off the appliance.

• Close the water supply, if necessary!

• Remove the dishes after cooling (see "Unloading

the dishwasher").

• Leave the appliance door slightly open until the

next rinse cycle to avoid odors.

• If the appliance is not in use for an extended peri-

od, disconnect it from the power supply!

Unloading the dishwasher

CAUTION:

Let the dishware cool down for about 15 minutes

before unloading. Hot dishes are sensitive to knocks.

NOTE: : : :

NOTE

At the end of program there could be still water drops

inside the appliance.

• Open the appliance door and pull out the basket.

• To avoid water dripping from the upper basket

onto the dishes in the lower basket, it is advisable

to unload the appliance from the bottom up.

Energy saving tips

• Always try to operate the dishwasher when it is

fully loaded.

• Do not rinse the dishes in advance under running

water.

• Use for each type of load the most appropriate

rinse program.

• Do not perform a pre-rinse (depending on model),

if not absolutely necessary.