BOMANN GSP 861 Instruction Manual page 6

• Take care of a solid and horizontal position of the
appliance. If the appliance is not horizontally lev-
eled, adjust the feet accordingly (see "Adjust the
feet").
• Power cord and water hoses may not kinked or
squashed.
• Avoid the installat Avoid the installat Avoid the installation: Avoid the installat ion: ion: ion:
near heaters, next to a stove, direct sunlight
-
or any other heat sources;
at locations with high humidity (e.g. out-
-
doors), as metal parts would be susceptible
to corrosion under such circumstances;
in rooms where the temperature could drop
-
below freezing. Do not expose the appliance
any weather.
near volatile or flammable materials (e.g.
-
gas, fuel, alcohol, paint, etc.).
Removing the appliance cover Removing the appliance cover
Removing the Removing the appliance cover appliance cover
The appliance cover can be removed and thus re-
ducing the device height to 81.5 cm; to place the
dishwasher under a suitable kitchen worktop.
a) a) a) a) Loosen the screws on the unit
back and remove the cover.
b) b) b) b) After removing the cover, re-
tighten the screws.
Adjusting the feet Adjusting the feet Adjusting the feet Adjusting the feet
Check with a spirit level whether the
appliance is leveled horizontally. If
the unit is not in balance, the feet
must be adjusted.
Water connection Water connection Water connection Water connection
CAUTION: CAUTION:
CAUTION: CAUTION:
• The Installation of the water supply must conform
to the local laws and regulations.
• The appliance is not not not not suitable for hot water supply.
CAUTION: CAUTION:
CAUTION: CAUTION:
• Use the new supplied hose set to connect the
appliance to the water supply. Do not reuse old or
used connection sets.
• If the water pipe is new or long time not used,
ensure before connecting to the water system,
that the water is clear and free from contamina-
tion.
Notes on inlet hose saf Notes on inlet hose saf Notes on inlet hose saf Notes on inlet hose safety system (delivery scope
depending on model) depending on model)
depending on model) depending on model)
The safety system consists of a double-walled inlet
hose. It guarantees to cut off the water supply when
leakage of the inner hose. Switching off the water
supply leads over an electronic contact.
If necessary, you can order an inlet hose safety sys-
tem from your dealer or in our online accessories
shop, www.bomann www.bomann- - - - germarny.de www.bomann www.bomann
reference number found under "Technical Data".
Connect the water inlet h Connect the water inlet h Connect the water inlet h Connect the water inlet hose (cold water connection)
NOTE: : : : NOTE NOTE NOTE
The water pressure must be between 0.04-1.0 MPa.
With higher pressure: use a pressure regulator.
• Connect the water inlet hose to a
water thread with ¾". Screw the
hose firmly in the direction of the
screw thread; pay attention for a
tight fit.
• Connect the other end of the inlet
hose to the inlet valve on the appli-
ance back; pay attention for a tight
fit too.
Connect the water drain hose Connect the water drain hose
Connect the water drain hose Connect the water drain hose
NOTE NOTE NOTE NOTE: : : :
The drain hose has a length of approx. 1.5 m and
can extend with a suitable hose and connecting
piece to a length of max. 4 m.
6
ety system (delivery scope ety system (delivery scope ety system (delivery scope
germarny.de. To order, use the germarny.de germarny.de
ose (cold water connection) ose (cold water connection) ose (cold water connection)