Maintaining Your Vacuum; Emptying The Dust Cup; Cleaning The Filters - Shark 250 Series IC205 Series UF280 Series Instructions Manual

MAINTAINING YOUR VACUUM

WARNING: To reduce
the risk of shock and
unintended operation,
turn off power and
remove the ION Power
Pack before servicing.
WARNING: Hand wash
filters only with water
to prevent damage from
cleaning chemicals.
Allow ALL filters to air-
dry completely before
replacing them in the
vacuum to prevent
liquid from being drawn
into electric parts.
IMPORTANT: Clean the
dust screen inside the dust
cup as required.
NOTE: Empty dust cup when
debris reaches the MAX fill
line.
RECOMMENDED
FILTER CLEANING
SCHEDULE:

EMPTYING THE DUST CUP

Pre-Motor Filter Kit
1 To empty dust cup, first remove the handheld vacuum from
(Foam & Felt)
the wand by pressing the Wand Release button and pulling
Clean once a month.
up on the handheld vacuum.
2 Position dust cup over a trash bin, then open the bottom of
the dust cup by pressing the Dust Cup Release button on
the side.
13
s h a r kc l e a n . c o m
Wand
Release
FILTER COVER LID
FOAM FILTER

CLEANING THE FILTERS

1 To clean the foam filter, remove the filter cover lid on the top of the handheld vacuum and
slide off the foam filter. Rinse foam filter with water. Tap loose dirt off filter between washes
as needed. Once completely dry, reinsert the felt filter and close the filter cover lid.
2
To clean the felt filter, remove the cover on the bottom of the handheld vacuum by pressing
the release button. Remove felt filter. Rinse with water. Once foam filter is completely dry,
return it to the filter frame, then replace the filter frame and the filter cover.
FILTER FRAME
FELT FILTER
s h a r kc l e a n . c o m
14