Weber SmokeFire EX4 Owner's Manual page 20

TROUBLESHOOTING
E1 Auger Jam
Clearing an Auger Jam
To clear the E1 error code from the controller, please follow these steps:
1. When the barbecue has completed the shutdown procedure and completely
cooled, power off the barbecue and unplug from the power source.
2. Remove the cooking grates, FLAVORIZER BARS, heat diffuser, and heat baffle
from the cookbox. (A).
3. From the rear of your SMOKEFIRE barbecue, place a large bucket or
container underneath the middle of the hopper (B).
4. Pull the hopper slide door located on the rear of the hopper to release the
pellets into the container below (C).
5. From the rear of your SMOKEFIRE barbecue, remove the rear access panel
by removing four screws (D).
6. Disconnect the wire connection from the motor by pinching the clip and
pulling the quick disconnect plug. (E).
A
20
B
C
D
E